SP-404SX/A EXTRAfirmware

Tape-style varispeed for every pad, a chromatic keyboard mode (pads and MIDI), chop mode (equal slices across a bank's pads), mute groups and per-pad pan on the Roland SP-404SX and SP-404A (same firmware, works the same on both).

Release …

1Get Roland’s official update

Download SP-404SX System Update Version 1.07 from Roland’s support page and unzip it. You need the file sp404sx_up.bin inside, unchanged. SP-404A owners use this same file.

This site contains no Roland code. It only adds this project’s changes to your copy of Roland’s file.

2Make the EXTRAfirmware file

3Install it

  1. Back up your SD card. Use a card formatted by the SP-404SX/A with at least 2 MB free.
  2. Copy the downloaded sp404sx_up.bin to the root of the card (keep that exact name).
  3. Power off the SP-404SX/A, insert the card, connect the AC adaptor (not batteries) and power on.
  4. The display shows UPd and then Fin after about ten seconds. Never power off while it says UPd.
  5. Power off, take out the card and delete sp404sx_up.bin from it on your computer (otherwise it updates again at every power-on), then put the card back in the SP-404SX/A.

To check the install, hold MARK while powering on: the display shows 2.30 (stock shows 1.07). To go back to stock or an older release, first turn chop mode off on every chopped bank, then install that file the same way.

What it adds

Varispeed

Chromatic mode

Chop mode

Mute groups

Pan

Saving and stock behaviour